Newby here, 2013 CB1100A
|
Author |
Message |
Lord Popgun
I find your lack of RLETs disturbing
Virginia Beach
Posts: 10,442
Joined: Apr 2013
|
RE: Newby here, 2013 CB1100A
Yep, they all have a speed sensor ring on the rear wheel. For 2013 ABS model only, the brakes are linked and thus have the crossover hoses.
On ABS bikes there are 2 speed sensors. Front and back. On NON ABS bikes the sensor on the rear provides information to drive the speedometer, ECU, etc.
And just so you know, there is no rear only ABS. And a lot of salesman told us we had that, even after corrected, even when, in my case the service manager/head tech told him it did not.
Also if you had ABS, you would have an ABS light that goes out at about 6MPH IIRC.
If you come to a fork in the road, take it!
2013 CB1100
2012 ST1300
Holder of the CB1100Forum Secret Decoder Ring
|
|
07-14-2017 03:12 PM |
|
The ferret
Forum Moderator
Ohio
Posts: 31,282
Joined: Apr 2013
|
RE: Newby here, 2013 CB1100A
Howdy and welcome to the forum. Still a beautiful, well made bike regardless as to whether it has ABS or not.
.
Defender of the Realm
2014 DLX (the pleasure horse)
2021 NC750X DCT (Angry Bird)
|
|
07-14-2017 04:34 PM |
|
CB_Nostalgia
Break-In Period
Katy, TX USA
Posts: 6
Joined: Jul 2017
|
RE: Newby here, 2013 CB1100A
(07-14-2017 01:24 PM)Pauley Wrote: Regarding 2013s (I have a 2013, don't know what other years look like, I would imagine they are similar), all have the ring and sensor on the rear wheel. The ABS models have another ring and sensor on the front wheel and brake lines are plumbed a bit differently, most notably is the hose wrapping over the fender - on the ABS models, one of the slave cylinders on the right front caliper is linked to the rear brake resulting in the different routing of the hoses.
I appreciate everyone's warmth welcome.
No ring in the front wheel, so it is a standard one! I guess one less thing to go bad...
By the way, I am done with the tune up, the 14" Delkevic arrived today and was just installed (no baffle). Weather permiting, I am out tomorrow for a spin!
|
|
07-14-2017 07:07 PM |
|
Cormanus
Moderator
Queensland, Australia
Posts: 20,660
Joined: Dec 2013
|
RE: Newby here, 2013 CB1100A
Good to hear CB_N. Hit the road!
|
|
07-14-2017 07:15 PM |
|
curlyjoe
High Mileage
Massachusetts
Posts: 1,323
Joined: Jul 2014
|
RE: Newby here, 2013 CB1100A
Congrats on the '13 CB and welcome to the forum!
2013 CB1100 ABS
2008 ST1300
|
|
07-15-2017 04:16 AM |
|
Lord Popgun
I find your lack of RLETs disturbing
Virginia Beach
Posts: 10,442
Joined: Apr 2013
|
RE: Newby here, 2013 CB1100A
CB, let us know your thoughts on your new Delkevic after you "break it in" so to speak, LOL
If you come to a fork in the road, take it!
2013 CB1100
2012 ST1300
Holder of the CB1100Forum Secret Decoder Ring
|
|
07-15-2017 07:09 AM |
|
Lord Popgun
I find your lack of RLETs disturbing
Virginia Beach
Posts: 10,442
Joined: Apr 2013
|
RE: Newby here, 2013 CB1100A
CB, if you are interested, here is what the front end of a '13 ABS looks like:
http://cb1100forum.com/forum/showthread....#pid177951
If you come to a fork in the road, take it!
2013 CB1100
2012 ST1300
Holder of the CB1100Forum Secret Decoder Ring
|
|
07-15-2017 11:30 AM |
|
CB_Nostalgia
Break-In Period
Katy, TX USA
Posts: 6
Joined: Jul 2017
|
RE: Newby here, 2013 CB1100A
Took it out for a short 30 mile spin, ran like a champ.
The 14" Delkvic Oval did a good job, forget about the baffle...
I took it out even before installing the muffler. Robust, deep tone, not loud, just right.
The only thing is about the clamps, too little screws in my opinion. If you are planning on having it in and out, in addition to a new graphite gasket, order a couple of clamps too.
I don't believe they can be tighten twice before giving up on the threads.
And what a change the clutch fluid flush did (brakes too, most noticeable improvement in the clutch actuator), so smooth now.
The new set of spark plugs took care of the hesitation while accelerating as the fresh fuel was not the fix.
One of the old spark plugs did not look good anyway, probably that was it.
(07-15-2017 11:30 AM)popgun Wrote: CB, if you are interested, here is what the front end of a '13 ABS looks like:
http://cb1100forum.com/forum/showthread....#pid177951
Yeap, it is a std. one! No extra stuff in the front, no abs light, thank you for the correction. Newbies....
(This post was last modified: 07-15-2017 04:30 PM by CB_Nostalgia.)
|
|
07-15-2017 03:46 PM |
|
venturer434
Running Like a Top
Vancouver, BC, Canada
Posts: 292
Joined: Aug 2013
|
RE: Newby here, 2013 CB1100A
Howdy and welcome to the Forum.. may be we should catch up on a ride some day..
Yamaha RD350B
2001 Triumph Bonneville
2004 BMW R1150RT
2014 Honda CB1100 STD
|
|
07-18-2017 10:10 AM |
|
|
Forum Friends
|
|
Recent Posts
|
Triumph Thruxton RS Final Edition
|
Mr. P: Sounds like another situation th . . .GoldOxide — 05:42 AM |
Triumph Thruxton RS Final Edition
|
peterbaron — 05:37 AM |
Triumph Thruxton RS Final Edition
|
my take is, if you get it and make it wh . . .m in sc — 05:32 AM |
Triumph Thruxton RS Final Edition
|
But is he really $2,000 ahead? A 3 . . .misterprofessionality — 04:31 AM |
Triumph Thruxton RS Final Edition
|
But is he really $2,000 ahead? A 3 mod . . .m in sc — 03:32 AM |
Triumph Thruxton RS Final Edition
|
Interesting dilema, Mr. P... my vote wou . . .pdedse — 08:16 PM |
Triumph Thruxton RS Final Edition
|
The same bike not even broken in wit . . .Ollie — 08:09 PM |
Triumph Thruxton RS Final Edition
|
I've been riding since I was a kid a . . .The ferret — 07:52 PM |
Statistics
|
» Members: 6,521
» Latest member: gregb6718
» Forum threads: 15,974
» Forum posts: 329,792
Full Statistics
|
|
|