Threaded Mode | Linear Mode

**Cormanus** · 04-15-2018 01:50 PM

This is how you change oil, http://cb1100forum.com/forum/showthread.php?tid=10993

Flynrider · 04-16-2018 02:42 PM

(04-15-2018 06:48 AM)PowerDubs Wrote: When I was just a few years into driving, I changed the oil on a car but did not notice the old rubber seal from the filter stayed stuck to the block. Needless to say 2 rubber seals do NOT work better than one.

Talk about a huge mess.....

Even worse on a CB, as the filter will dump the oil right in front of the rear tire. I think I've seen a few posts over the years where someone on the forum made this mistake.

One of the things I always do after removing the old filter is to run my finger around the seating surface to make sure it's smooth and free of debris.

TCinNC · 04-16-2018 03:22 PM

(04-15-2018 01:50 PM)Cormanus Wrote: This is how you change oil, http://cb1100forum.com/forum/showthread.php?tid=10993

It ended up being not so bad. Cleaned up the drain pan and only lost half a quart when I pulled the drain plug and put the washer back on. All is good!