(08-26-2015 04:35 AM)Cormanus Wrote: I hope you're going to repaint the tank and the fairing in Ural green.
My wife was commenting I should paint the ammo cans black to match the bike. I'm leaning on that route at the moment because the green on these cans is a dark forest green more than OD green. I will see if I can get them to fade first.
KennyW
08-26-2015 09:27 AM
kennyw
High Mileage
Gold Bar
Posts: 1,407
Joined: May 2015
Took the rear fender and factory turn signals off again. With a little paint, the new brackets were remounted with the new turn signals.
Next, routing wires under the taillight and into the fender. One new half inch hole drilled in the fender with a grommet to bring the wires under the seat.
Extra 3/8 indinch holes were drilled in the plastic piece for routing wires.
After that, the new assembly is reinstalled on the bike.
Next will be wiring. I just ran out of time and energy to finish it up tonight.
KennyW
(This post was last modified: 08-27-2015 10:24 PM by kennyw.)
08-27-2015 10:11 PM
kennyw
High Mileage
Gold Bar
Posts: 1,407
Joined: May 2015
I should also mention that these lights had long enough wiring to route all the way up to the battery area where they need to be connected unlike the cheap ones I had in earlier pics.