(07-09-2013 08:59 AM)silascopathic Wrote: (07-09-2013 08:09 AM)The ferret Wrote: Dont have a diy...if we had one that would be in the How To section. Believe it is very straightforward but you will have to drill pin locators for the switches in your new bars. Measure twice, or thrice, drill once.
Thanks man! The holes shouldn't be an issue its just removing the tops of the risers.
I'm sure I will get it
those are just plastic caps that press into allen head bolts. I used a very small thin screw driver to lightly pry them up.
It would help to have something without sharp edges.