bar end removal

[modmaster]

So far from what I read on Chip Beck's handle bar thread, to remove the entire bar end weight assembly as a unit you have to depress the two spring steel tabs at the same time and the unit should all slide out. Is that correct?

modmaster

[kmoney]

Correct. You will need to remove (or possibly pull back) the grips in order to expose the two holes as well.

[modmaster]

kmoney. Thanks for the reply.

modmaster

[p32077]

removing the inserts does that have any affect on the performance on the bike

[IndianRider]

I figured out how to remove the stock long internal bar end damper by depressing those 2 clips first AFTER I replaced handlebars with aluminum enduro style wider/ taller bars and installed extra heavy weight Hudson Valley Motorsports parts bar ends and the bike is waaaayyy too smoooth now ..

Here is a generic pic


Sent from my iPhone using Tapatalk

[mrded]

Hey, I just removed internal cartridges and it’s actually a very simple job. You just need to press two pins and pull a cartridge.